ENGLISH
中文版PRODUCT NAVIGATION
Experience of using X3X5 digital front effect device
First：The machine problem:
1. USB to 232 male line (recommended brand Lite) connected to re-use the original distribution of the 232
USB bus (the original 232 USB line preamp, line connected to the computer, note: you cannot directly use the
USB online)
2. The public line need to install the driver, you can use the driver wizard or drive the life of the search to install the appropriate driver.
3. Computer port COM is less than 8
Two：Wireless microphone inserted the first, second sockets, wired plug third sockets; fine-tuning resistance
probably in 12 to 3 points in the adjustment
Three：The music volume in small ＆#118alue and volume not linearly proportional to the best music around 35 microphone reverberation at around 25 level in 30, the channel one hundred percent ultra low delivery ratio is controlled within 200.
Four：The microphone can be appropriate according to the need to do high pass low cut, reverberation bandwidth can be as wide as possible, so that more color
Five：Switch machine has small impact if the power system had better switch sequence
Six: The main road delay function with the proper adjustment of the characteristics of loudspeaker box will have a surprise
Seven: Singing and dance mode mode can be selected automatically and manually change. If you want to automatically switch, first manually debugging, and then automatically; when the microphone is opened, automatically switch to singing mode, when the microphone is closed after 5 seconds, automatically switch to hot dance state.
Eight： In addition to X5 X3 and more than two other functions like rear channels; R M8 R (G').
Nine:Try to reduce the use of DSP resources, not too fast or frequent pull down interface function; PK, if there is the same effect, the best not too close
Ten：The stored data try not to store in the first mode, the model can not be within the PASS state, otherwise
there will be a slight noise